TJ stuff

[TJDave]

I have a lot of stuff off of a 2004 TJ with low miles. 40,000 Mostly stock stuff.

Teraflex next gen. greasable swaybar disconnects with storage pins
stock front swaybar and mounts
stock tire carrier
Control arms--upper and lower rear, lower front.
rear springs--heavier hard top model spring rate
gas tank skid--03 and newer are supposed to be thicker than previous years
Stock transfer case skid--Works great for excavating the center of a deeply rutted trail.
Stock slip yoke rear driveshaft
Stock transmission skid
Stock exhaust system--Nothing wrong with it, just wanted a new one.
Dana 35 axle 3.73 gears--almost complete..minus one shaft.
TJ Dana 35 e brake cables for stock drum brakes.
LP Dana ring and pinion--3.73
Heavy steel nerf bars/steps.
Stock front brake lines with extender brackets
Stock rear bumper with solid rubber end caps.
Frame mounted rear 2" receiver hitch.
I also have stock front and rear trackbars and tie rod. I was thinking of keeping these as trail spares, but if anyone really needed them.....

I am not sure what any of this stuff is worth......but I like Crown Royal.

[iaccocca]

Let me know what you want for the lower control arms.

[Grumpy]

Sounds like some quantity of Crown could do it

[YJ 2 XJ]

pics of steps???? or description....

[TJDave]

pics of steps???? or description....

Steel, tubular, black, non skid tape on top. They are heavier/thicker than all the chrome ones you see at the mall. They were spot welded to my frame but could be bolted. I'll try to take a pic of the ends tomorrow.

[mattawajeep]

Whatcha want for the exhaust? Mine has rusted through in a few places (hole in the muffler ect...) and being cheap is always good.

[TJDave]

How 'bout some..................uhhhh.............Crown Royal!

Maybe just a pint cause I hacked off the very end of tailpipe to try to use as a turn down on my new muffler. Didn't work. Too small. I ended up hacking a piece of my new exhaust to use as one.

Muffler is still good. Has the flange on it. Tailpipe is still good too if you need it. You'll just have to re-attatch the last 6 or 7 inches somehow.

[mattawajeep]

That should work - I mostly need the muffler - but the tailpipe has some bad sections too. If yours is mostly rust free I should be able to weld the piece back on without too much trouble, or make it work somehow. My brother is going to be up in tri-cities on monday with a truck and can probably stop by and make the trade. Shoot me a pm with your address and we can get it worked out.

[TJDave]

Bump...I still have all this stuff. Prices so reasonable, I'd have to pay you to take them if they got any lower!!

New items to add to the list:

Teraflex next generation greasable swaybar disconnects with storage pins.
Stock front swaybar and mounts.
Stock rear tire carrier.

Try not to run into each other on Y'alls rush to get over here!

[mr. jones]

when are you going to sell one of your d30's?

[TJDave]

Good question. I still have the HP30, but I am waiting to see if I have a job in a couple of months to build it.

Hopefully, Wastecan Wally will not turn into $h!tcan Sam.