amc 258 bellhousing
Posted: Thu Mar 11, 2010 5:04 pm
if anyone has one that could be bought off it would be much appreciated.
Page 1 of 1
Posted: Thu Mar 11, 2010 5:10 pm
Posted: Thu Mar 11, 2010 8:27 pm
iaccocca wrote:
its a movie
Posted: Thu Mar 11, 2010 10:08 pm
not sure if I tossed it or not, I'll check tomorrow in the daylight.
It would be from a '74, 304 but should work fine.
It would be from a '74, 304 but should work fine.
Posted: Fri Mar 12, 2010 6:51 am
There are several different AMC bellhousings. All of them bolt up to the 258 except the ones that were on the 2.5. . .the trick is getting the right one for the tranny.
There is a T14/15, T18(short), T18A (that also fits the T176 and T150), the SR4/SR5/T5, the AX15 and probably one for the BA-10.
Which one do you need!!?
There is a T14/15, T18(short), T18A (that also fits the T176 and T150), the SR4/SR5/T5, the AX15 and probably one for the BA-10.
Which one do you need!!?
Posted: Fri Mar 12, 2010 12:00 pm
its for a T150
Posted: Fri Mar 12, 2010 12:06 pm
and ive been told it cant have a slave cylinder
Posted: Fri Mar 12, 2010 1:02 pm
Yep. . .it uses a bell crank.
Call Tony at Applied Industrial Technologies in Pasco and ask him if he has one. He used to have a couple of them laying in his shop.
Call Tony at Applied Industrial Technologies in Pasco and ask him if he has one. He used to have a couple of them laying in his shop.