Looking for a Holley 4160 390 cfm carb., vacuum secondaries, electric choke.
Also, looking for a hydroboost setup, pedal assembly to steering pump would be best. Going in a flat-fender.
Let me know, thanks!
Wanted....
Moderator: TJDave
Re: Wanted....
Duckman wrote:Looking for a Holley 4160 390 cfm carb., vacuum secondaries, electric choke.
Would this work??
https://portland.craigslist.org/clk/pts/4908065221.html
_____________________________
95 YJ LS6 Conversion
95 YJ LS6 Conversion
You looking for the orange Jeep?
If so stay away from the big carb and put a stockish 2jet. Won't be the big power but will run well and give decent power.
Actually that engine should have that carb on it.
I'm also going to guess a carb off a 360 will flow way to much for a 3.8.
If none of this applies, ignore.
If so stay away from the big carb and put a stockish 2jet. Won't be the big power but will run well and give decent power.
Actually that engine should have that carb on it.
I'm also going to guess a carb off a 360 will flow way to much for a 3.8.
If none of this applies, ignore.
James
'92 YJ with a little something of everything.
'92 YJ with a little something of everything.
Remember that engine has stock compression for a 1978 at about 7.5 or something close to that. It also has the low port (early) heads and don't flow like the later models do.
I over cammed, manifold, and carb'ed (465cfm holley) it which made it not happy and very temperamental, stock was much better.
IIRC correctly, it has a performer cam or something close to that spec in it now.
I over cammed, manifold, and carb'ed (465cfm holley) it which made it not happy and very temperamental, stock was much better.
IIRC correctly, it has a performer cam or something close to that spec in it now.
James
'92 YJ with a little something of everything.
'92 YJ with a little something of everything.
Return to “For Sale and Wanted”
Who is online
Users browsing this forum: No registered users and 6 guests