PEAK PUTTERS

I looking for the factory u-bolts and plates for the rear axle from a late 80's - early 90's Toyota PU. Anyone have them sitting around?

SPR wrote:I looking for the factory u-bolts and plates for the rear axle from a late 80's - early 90's Toyota PU. Anyone have them sitting around?

I have some plates and maybe some U-bolts, but would have to match up the measurements.

So let me get this straight: You are using 2.5" wide springs and perches, right? What is the axle diameter?

i have facorty ones i think

factory ubolts and plates are square ubolts and formed plates with shock mounts

The axle tubes are 3" diameter and the spring perches are 2.5 wide. I was hoping for factory hardware to match up with my current shock mount arrangement. I could make my own flip kit but I'm not ready to modify my shock mounts and/or purchase new shorter shocks.

which way are you mounting your u-bolts, over or under?

Factory style like the first picture.

I would go like the second style if you can. I've seen the first style cause rigs to get hung up.

SPR wrote:Factory style like the first picture.

if you go with the first and you change spring perches you shouldn't need different sized u-bolts. and really you could probably notch your current spring perches. correct?

Steve all i have are the stock narrow ones

Steve, I have another set of plates if those dont work.

I have a simple sharpener for ski bottoms and edges that I can let go. Perhaps we can swap stuff. I'll give you a call Sunday.