Operation "Kinda' Like an Expedition Rig" (aka "I Hope I don't Burn my Jeep Down.")
Pilot holes... then comes the hole saw.
Passenger side, rear corner.
Lee
Projects... or what the hell is Lee up to?
Projects... or what the hell is Lee up to?
Okay, we're a little crazy to have a Duramax for a daily driver. But if we go off our meds, we might wind up in a Prius.
If you want to hear God laugh, tell Him your plans.
N7EEL WROD249
If you want to hear God laugh, tell Him your plans.
N7EEL WROD249
Mod not done, but the reason for doing it is to have power at the back of the Jeep for the 12 volt air compressor, inverter, tent trailer heater, etc., without opening the hood.
Solenoid is from Amazon. The 500 amp one is actually going to replace the 200 amp one used for the dual battery setup. The 200 amp solenoid will be the 'switch' for the rear power, so the terminals won't always be hot. The rear power will be fused / rated for 200 amps, so not for jump starting.
200 amp = $44.00
500 amp = $73.00
Lee
Solenoid is from Amazon. The 500 amp one is actually going to replace the 200 amp one used for the dual battery setup. The 200 amp solenoid will be the 'switch' for the rear power, so the terminals won't always be hot. The rear power will be fused / rated for 200 amps, so not for jump starting.
200 amp = $44.00
500 amp = $73.00
Lee
Okay, we're a little crazy to have a Duramax for a daily driver. But if we go off our meds, we might wind up in a Prius.
If you want to hear God laugh, tell Him your plans.
N7EEL WROD249
If you want to hear God laugh, tell Him your plans.
N7EEL WROD249
I have the 200A version on my dual battery setup for my Bronco. I am considering options for a dual battery setup for my Mountaineer, that is why I asked.
I am curious about how you are going to connect accessories to the terminals you have there. At first glance they do not seem to be a screw on stud type of thing from the top side.
I am curious about how you are going to connect accessories to the terminals you have there. At first glance they do not seem to be a screw on stud type of thing from the top side.
1997 Monsterneer
1967 Bronco (Bonchole)
10m, 2m 146.535, 70cm=KI6MCO, CB ch27=Apollo 3, GMRS ch7,
1967 Bronco (Bonchole)
10m, 2m 146.535, 70cm=KI6MCO, CB ch27=Apollo 3, GMRS ch7,
Return to “Projects and Build-Ups”
Who is online
Users browsing this forum: No registered users and 2 guests