PEAK PUTTERS

well, UPS is not going to deliver my adj. track bar until this Tue.-I think the brown trucks are governed @ 60mph. Springs are still sitting here. Was hoping for some install help before Fri's Darland run/campout. If not, maybe after, and I will have to run lowboy in the snow thank-you, Dave.

What's the plans for your stock coils? I've got a 2003 Wrangler that I'd like to bring back down to size.

if these work, you are welcome to the stock ones. If my front end sits too high after a winch, I'll have to get some rear ones as well. Maybe OME 2.5". The goal is to have it sit close to level. If I need new rear springs, you can have those as well. But, I have to get them off first do you know what kind of coils and how much lift is on your TJ?? Maybe we could swap. I'm stock with 2" spacer.

help? i can help!

call me, al

The coils I have are red in color and I estimate to be between a 2-4" lift. It raises a Rubicon enough to fit 35" tires. I'm all for a trade if they'd work for you. Scumbys help would be great.

oddball wrote:The coils I have are red in color and I estimate to be between a 2-4" lift. It raises a Rubicon enough to fit 35" tires. I'm all for a trade if they'd work for you. Scumbys help would be great.

hmm...tempting. I planned on new 33's when my 32's wear out. I don't think my drivetrain could handle 35's until I do some major mods and axle swappage. If they are 2-3" they will work. These Rusty's 3" front springs should do for a while, but you can still have my stockers. If I remember right, they are #129---same front spring rate as a stock Rubi. Al--your help would be much appreciated, again! I will call you when my trac-bar arrives. Are they still producing that same brew you like??

What adjustible track bar did you go with? cost?

Ordered one from Rusty's offroad. $150.00 including shipping. Was alot cheaper than what JKS wanted for theirs, $250+ shipping. I hope it is just as good. Maybe I can look at your TJ and bring one of my Rusty's springs and a tape measure and we can try to figure out how big the lift is. If I can use your springs all around, maybe you could use the Rusty's 3" front and the stockers with the 2" spacer in the rear like I was going to do?????

Let me know what night you are going to do this and I will see if I can get over and help. (And, I'd like to take a look at that track bar.)

Crawling around under my Jeep this morning...looking at the rear track bar set-up. I need a stock TJ to compare to: my rear axle is perfectly centered with the 2" spacer lift so I don't know if there is a trackbar bracket installed previously. If there is, it is one of the weld-on types, and I would need an adj. rear track bar too, if I lift my rear more. had to take one of my stupid dogs to the vet yesterday-again-and that took another big bite out of my Jeep fund. Bwah ha, get it?, big bite out of......anyway, might have to stick w/plan "A" unless Oddball's rubi has something to swap out in the rear.

Bring it over and compare. Phone # 545-6465, Curtis.