I was the only one with a camera so I guess I'll post up. This was supposed to be a small tire run under 31" tires but it ended up being a free for all. Trash was busy late with Zach's rolled Yota, so he did not have time to swap out to smaller tires on the iZuZu. I got rid of the Rubi wheels and tires so I had my (still small) 33's. Wrench just got rid of his 31's and had a brand new set of 33's, I think. Tim actually put a set of bigger tires on his bunny, but they were under 31" We arrived at Hover Park and met GetzPaid in his very nice Tacoma daily driver. We tooled around for awhile before Trash, Peanut, Reco, and group showed up with the amazingly still running iZuZu, and some quads. Had a good time, especially watching Trashy thrash on the green thing that won't die. Here's the pics:
Still clean
Check out the Bunny Flex!!!
Bunny pulling out a Rodeo
Hard too see due to almost being dark but WT's driver's rear tire is about 4 feet off the ground!
Was a great time, I have not been to that side before.
Hover 05/01/10
Hover 05/01/10
Last edited by TJDave on Wed May 05, 2010 9:41 pm, edited 2 times in total.
2018 JLU Rubicon
Tow bar mount
Trailer hitch
Tow bar mount
Trailer hitch
- White trash
- Posts: 1763
- Joined: Tue Jan 22, 2008 9:38 pm
- Location: El Pasco
That stuck was pathetic... I pulled down there and saw the ruts and thought to myself.... Well that looks like it may be deep.. Idled in and it just stopped. No throttle needed it wouldn't move at all.
Good times even if it was only for a while. The izuzu lives on... Might head to juniper tomorrow to try and finish off whatever that is popping up front.
Good times even if it was only for a while. The izuzu lives on... Might head to juniper tomorrow to try and finish off whatever that is popping up front.
- CopenhagenCowboy
- Posts: 257
- Joined: Sat Oct 10, 2009 4:00 pm
- Location: Kennewick WA
- CopenhagenCowboy
- Posts: 257
- Joined: Sat Oct 10, 2009 4:00 pm
- Location: Kennewick WA
-
- Posts: 121
- Joined: Tue Oct 07, 2008 9:08 pm
- Location: Kennewick, WA
Return to “Slab / Weber / Hover / A&B”
Who is online
Users browsing this forum: No registered users and 1 guest