Page 1 of 1
SII parts source?
Posted: Sat Jan 17, 2009 5:42 pm
by Roman
Just curious for Steve's (morejeepthan)Scout.
Rear wheel well patch panels, fuel filler hose
Posted: Sat Jan 17, 2009 5:46 pm
by Roman
Hey Steve, don't you have a pair of these laying around? They're sell for $119 each new . . .
http://scoutparts.com/products/?view=pr ... t_id=13835
Posted: Sat Jan 17, 2009 9:18 pm
by benw
Don't buy anything from scoutparts.com. They are well known to target Scout newbies that don't know any better with their rediculous prices. Use IH Only North
http://www.ihonlynorth.com/ . They will take care of you, if they don't have something they will be able to tell you where to get it.
Posted: Sun Jan 18, 2009 4:59 pm
by NickO
Super Scout Specialists has most everything, including patch panels. . .
http://www.superscoutspecialists.com/store/default.aspx
Posted: Sun Jan 18, 2009 5:03 pm
by Grumpy
Do I need to go look at the filler hose?? It was fine at one point...
Posted: Sun Jan 18, 2009 5:39 pm
by Xj4x4
If interested I have a patch panel. I had 2 but can only find one. I also have a hood, grille, windshield frame and tailgate that you can have
Posted: Sun Jan 18, 2009 5:43 pm
by Grumpy
XJ4x4 wrote:If interested I have a patch panel. I had 2 but can only find one. I also have a hood, grille, windshield frame and tailgate that you can have
"Have"? You have my attention!
Posted: Sun Jan 18, 2009 6:10 pm
by Xj4x4
Thought that may get your attention. I had a Scout II that I was rebuilding but in the process I found a Scout 80 that I put on the Scout II frame so I have a few body parts that I would let you have. I'll try to find the other patch panel too.
Posted: Sun Jan 18, 2009 7:27 pm
by Grumpy
That would be cool!! SII's being what they are, spare parts are welcome
...Uh, what happened to the rest of the SII
Posted: Sun Jan 18, 2009 8:06 pm
by Xj4x4
A guy from the justih club in spokane took the doors and top. Tub was scraped due to rust and the frame and axles were kept for the Scout 80.
Posted: Sun Jan 18, 2009 8:10 pm
by Grumpy
One of the JustIH guys is doing an engine swap in Nick's rig now...So, let me get Steve by the throat and we'll likely relieve you of some parts.
Posted: Sun Jan 18, 2009 8:35 pm
by Xj4x4
Sounds good, and I'll keep looking for the other patch panel
Posted: Mon Jan 19, 2009 1:52 pm
by Fozzie
Yeah,that stuff sounds good to have,I really need a right 1/4 wheel opening is toast.
Posted: Sun Feb 01, 2009 2:32 pm
by Grumpy
Shall we get set on relieving you of these parts? Can you make the meeting this week?
Posted: Sun Feb 01, 2009 6:37 pm
by Xj4x4
Yeah I should be able to make it. I ll get them loaded up and bring them with me. If I cant make it David could probably bring them too.
Posted: Sun Feb 01, 2009 9:47 pm
by Grumpy
You don't need to do a bunch of work. We can grab them from your place later. Likely not till after the guys get back from Parker, though. We can work that out at the meeting...
Posted: Mon Feb 02, 2009 5:32 pm
by Xj4x4
Sounds good.