PEAK PUTTERS

http://kpr.craigslist.org/cto/2287561887.html

if i could sell my runner, this would be in my driveway

toyman2 wrote:http://kpr.craigslist.org/cto/2287561887.html

if i could sell my runner, this would be in my driveway

anything someone see's that i might be missing, looks pretty dam nice to me.

toyman2 wrote:http://kpr.craigslist.org/cto/2287561887.html

if i could sell my runner, this would be in my driveway

OOOHHH, Nice red Dodge! I like it too.

It does not have a dana 35 front axle.

That is not an 8274.

I spy a hi lift jack that has never been used and the owner would be perplexed as to how to use it but installed it because it "looks rugged".

Money says that has a th400 hooked to a quadracrap. RUN!

Sweet shackle lift though.


If you want a nice looking project that's your huckelberry but I wouldn't hand over more than $4500 if you want to actually wheel it.

Think I would do something about rebuilding that rear bumper and tire carrier too. Those rings look a bit weak and I don't think I'd actually want to fill that gas can.

the T case and axles are a given.
im thinkin if i get a jeep itll end up with a 9" and d44 with mabey a d300.im sure ill do the normal changes, but i want more of a street driver than wheeler. i just dont hardly wheel anymore but i want it capible to do some wheelin.
thats kinda how my runner was suppose to end up, not sure what the hell happen.

Heck you already own the runner I'd just drop the tire size down and keep it. 35's and a 3rz swap would make it a nice driver and more than capable of what you want to do.

White trash wrote:It does not have a dana 35 front axle.

That is not an 8274.

I spy a hi lift jack that has never been used and the owner would be perplexed as to how to use it but installed it because it "looks rugged".

Money says that has a th400 hooked to a quadracrap. RUN!

Sweet shackle lift though.


If you want a nice looking project that's your huckelberry but I wouldn't hand over more than $4500 if you want to actually wheel it.

Seriously . . . the owner just doesn't know what he has. It isn't that uncommon. Not everyone uses an inverted axle shaft as a bar stool.

White trash wrote:Heck you already own the runner I'd just drop the tire size down and keep it. 35's and a 3rz swap would make it a nice driver and more than capable of what you want to do.

The whole point is somthing different, i have had toyotas for 18 years (oh crap that sucks to hear) ive never had a Heep CJ before.
my runner will do 75mph without issue and does good on gas rides nice and wheels great, im just tired of it.
time to polish a new turd

Get a Scout ......

Stay Japanese.