PEAK PUTTERS

I started pulling out all the carpet from my rig and I am going to attempt to replace it with a roll on bed liner throughout my entire rig. Has anyone done this on their own? If so what product did you use and how did it turn out?

I helped a buddy put a bedliner in his wrangler. I believe he bought the stuff at walmart, but I can't think of the brand name. It worked okay, but after a year it was wearing thin in a few points. Other than that he was happy with it

Edit - Herculiner is what my friend used.

I got mine done by Line-X as I was too lazy to roll it on myself - but for a DIY job the jeep guys swear by Monstaliner:

http://www.jeepforum.com/forum/f9/monst ... up-901675/

http://www.jeepforum.com/forum/f43/intr ... er-875162/

I've personally seen the results of some of the cheapo stuff you can get at parts stores - and the results aren't all that great after a while.

I have a suggestion: SEM Chip Guard. I have used this stuff quite a few times and it is really good. Available at any automotive paint supply.

http://www.google.com/products/catalog? ... CHIQ8gIwAQ

Two cans should be enough to do the whole floor inside if you dont hose it on too thick.

The best way I can describe it is that it is like spray-on ABS glue; even smells like it. It dries hard and can be top-coated if scuffed. Bond is excellent, as long as the surface is properly prepped. At bare minimum, everything should be cleaned thoroughly with wax/grease remover, then acetone, then scuffed with course (brown) scotch-brite until all gloss is gone. Preferably wet-sanded with ~220g, but the scotch brite is bare minimum.