Poll: Tcase for SYE. Pull it or not?
Moderator: TJDave
Poll: Tcase for SYE. Pull it or not?
Which way is easier? I intend to do this during this weekend.
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
I left mine in. Had it jacked way up in the rear.
Be very careful removing and replacing the stupid oil pump thingy. I broke the pick up tube collar off of mine, then had to wait over a week for a new one to show up.
Be very careful removing and replacing the stupid oil pump thingy. I broke the pick up tube collar off of mine, then had to wait over a week for a new one to show up.
2018 JLU Rubicon
Tow bar mount
Trailer hitch
Tow bar mount
Trailer hitch
Re: Poll: Tcase for SYE. Pull it or not?
Pull it, 6 bolts and some shifter linkage then you can do the job on the bench and NOT on your back!
Re: Poll: Tcase for SYE. Pull it or not?
if it can wait a couple weeks you can put it on the lift and never have to lay on you back. and that is to pull it or hack it in place.
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Re: Poll: Tcase for SYE. Pull it or not?
That might not be a bad idea. I could move up replacing my passenger side fender first.
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
I pulled mine. Pulling it makes it easier to separate the case.
Re: Poll: Tcase for SYE. Pull it or not?
Pull it, and DON'T forget the front output snapring like I did....
2018 JLU-R work in progress.
WRWP360
WRWP360
Re: Poll: Tcase for SYE. Pull it or not?
Jafo wrote:Pull it, and DON'T forget the front output snapring like I did....
PERFECT reason to pull the case! The snap ring on the front of the front output shaft is VITAL!
Re: Poll: Tcase for SYE. Pull it or not?
what'cha do sunday?
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Re: Poll: Tcase for SYE. Pull it or not?
Sounds good. I can get there early and get this done. What time are you thinking on Sunday? I might need some help on this and set of snap ring pliers. I'll also probably ask advice and help on setting my adjustable arms to get the new pinion angle right.
Also I don't have the drive shaft because I was waiting to get the right measurements for the length after this mod and the new skid installed. I may have to trailer this thing over or drive home in 4 wheel drive.
Hopefully after this I can get a drive shaft ordered and delivered fast enough so I can test it out on Memorial Day weekend. Lol
Also I don't have the drive shaft because I was waiting to get the right measurements for the length after this mod and the new skid installed. I may have to trailer this thing over or drive home in 4 wheel drive.
Hopefully after this I can get a drive shaft ordered and delivered fast enough so I can test it out on Memorial Day weekend. Lol
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
i can be ready to go by 0730. can it be driven over and driven back? or driven over and left until you get your shaft? i'll check for snap ring pliers. i'll help as much as i can. anyone else that wants to come help is welcome. i'm no expert on pinion angle but maybe someone else could chime in or advise on that. adjusting the the arms should be easy. was this hack and tap or full shaft replacement?
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Re: Poll: Tcase for SYE. Pull it or not?
I have snap ring pliers you are welcome to use. If you're planning on a CV rear driveshaft just aim the rear pinion at the t-case pinion.
Re: Poll: Tcase for SYE. Pull it or not?
I'm replacing the whole output shaft.
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
I found my snap ring pliers.
what time do you expect to be over sunday?
what time do you expect to be over sunday?
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Re: Poll: Tcase for SYE. Pull it or not?
I can get there by 8am. When I get everything done and refill the tcase I could probably put it in 4 hi and drive home at a slower speed. I'll have to rush order a drive shaft after I set the pinion angle and measure from the output shaft yoke to the yoke on the rear diff.
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
sounds good, you've been here before right?
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Re: Poll: Tcase for SYE. Pull it or not?
A few times. Could you PM me the address just in case?
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
Well Scumby, looks like I'll have to pass this weekend. Something has come up.
2004 TJ Wrangler X (Rubiclone)
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
2.5" OME Lift, 1.25 in Body Lift, Flat Fender Flares
35x12.50x15 Maxxis Razor MTs
D30 ARB 4.56s Rear JKD44 w/ 8.8 disk brakes Ford 9" goodies, 4.56 and ARB.
Re: Poll: Tcase for SYE. Pull it or not?
Lud wrote:Well Scumby, looks like I'll have to pass this weekend. Something has come up.
well bummer, now what am i going to do sunday?
Lightly Lifted and Locked LJ
I'm Scumby Dammit, take it or leave it!
I'm Scumby Dammit, take it or leave it!
Who is online
Users browsing this forum: No registered users and 80 guests