A finger bender had me singing the bender blues...
![Image](http://www.peakputters.com/forum/userpix/14_Blue_Fingernail_1.jpg)
White trash wrote:Use about a 6" piece for the sleeve. Leave about a 1/4" gap between them and drill the 1 3/4 for 3 or 4 plug welds each side.
Screaming Toylet wrote:Thanks for the comments. I bet the 1.5 tube that I messed with a Twin Cities Metal had just enough burr on the end to keep it form sliding into a 1.75 (.120 wall) tube. However, the guys behind the desk didn't think it would work.
OldGreen wrote:We sleeved some 1.5" with 1.25" from twin cities and it just slid right in. . .no sanding or deburring required.
Screaming Toylet wrote:Toby, I don't find your comment very useful, but I'm sure you didn't mean it to be.... thanks for nothing.
Return to “Projects and Build-Ups”
Users browsing this forum: No registered users and 33 guests