narrowing d44 housing
-
- Posts: 1204
- Joined: Wed Apr 11, 2007 7:48 pm
narrowing d44 housing
i need some help guys i want to cut my dana 44 down to narrower width and have never really done it before if anyone has and would like to help me do this let me know...i can dissasemble the thing so its just a housing and grind the inner c's off myself just need some guidance/knowledge help
-
- Posts: 1204
- Joined: Wed Apr 11, 2007 7:48 pm
-
- Posts: 1204
- Joined: Wed Apr 11, 2007 7:48 pm
-
- Posts: 1204
- Joined: Wed Apr 11, 2007 7:48 pm
so i traded chrispy my factory housing for one that had 4"s cut off the long side i ground it down and got the tube out of the inner c, i got it out and got the inner c back on that side i cut the weld and knocked the short side inner c off before it got too late
also picked up a set of jk44 gears from lance ive got my 30 spline lockouts a 3.73 carrier will be ordering up a jana 44 kit to put the JK gears in a normal housing will probably end up going with rcv shafts because of lees issues and i just dont know if any ujoint will survive even ctms
also picked up a set of jk44 gears from lance ive got my 30 spline lockouts a 3.73 carrier will be ordering up a jana 44 kit to put the JK gears in a normal housing will probably end up going with rcv shafts because of lees issues and i just dont know if any ujoint will survive even ctms
Return to “Projects and Build-Ups”
Who is online
Users browsing this forum: No registered users and 40 guests